i killed my phone..:( help!

[#1]

while updating my phone (x10 mini) i disconnected the USB cord bymistake.. and now it just wont get on..it jsut vibrates and a sign of a phone n error is displayed! please help!

[Uliwooly]

try this

Update Service (SEUS)

http://dl-www.sonyericsson.com/cws/download/1/110/61/1317636927/Update_Service_Setup-2.11.10.7.exe

Don't forget to mark the Correct Answers & Helpful Answers

[gwhispererz · Accepted solution]

Hi, don't worry .... just reflash software again.

Not sure what software did you use to update your phone, anyway, here's the download link to SE Update Service, http://dl-www.sonyericsson.com/cws/download/1/110/61/1317636927/Update_Service_Setup-2.11.10.7.exe. It does not require phone to be switched on during the software repair/update.

Download and install to PC/Laptop, launch it and follow on-screen instruction.

Don't panic, stay calm .... it will be resolved in no time.

[Uliwooly]

if SEUS doesn't work you can either

1) send it to SE repair center or

2) use flashtool (it will fix it)

http://talk.sonyericsson.com/message/139700#139700

Don't forget to mark the Correct Answers & Helpful Answers

[Uliwooly]

if you decide for 1)

http://www.sonyericsson.com/cws/common/contact?cc=gb&lc=en

Don't forget to mark the Correct Answers & Helpful Answers

[#6]

i used SEUS only..but im not able to mount my phone.. so i cant update or repair  it.. my phone just vibrates and a warning triangle with a yellow exclamation mark and a telephonic symbol appears on the screen..

[gwhispererz]

Don't make user panic  :smileywink:.... I bet reflashing of firmware should and will do the trick!

[gwhispererz]

Remove and re-install battery, then try again. Do not attempt to switch on phone.

[Uliwooly]

you don't have to mount your phone, your phone should be off when you connect it to your PC after you run SEUS

instal SEUS -> restart your PC -> run SEUS -> follow the instructions -> turn off your phone -> take the battery out -> wait few seconds -> put the battery back on -> do NOT turn on your phone -> press and HOLD the back button -> while still holding connect the USB cable -> do NOT release the back button -> wait -> your pc will recognize the phone

flashtool will work for sure

Don't forget to mark the Correct Answers & Helpful Answers