Sony FDR-AX700 connection to Gimbal

[cgarlick]

Hi, a question regarding my Sony FDR-AX700 connection to Manfrotto MVG460 Gimbal. I am trying to connect my camera to the above Gimbal using the proper connection cable USB from the Gimbal as seen in Picture below

I then connect the lead to my FDR-AX700 as seen in the picture below.

When I turn on the Camera and Gimbal I get the following message on the screen, I cannot make any connection to operate my Camera stop/start from my Gimbal. Any help would be helpful.

[danardeng]

mmmmm 🤔

seem that your camera is configured as “mass storage”, try to choose a different selection here

https://helpguide.sony.net/cam/1710/v1/en/contents/TP0001492480.html

[danardeng]

On Manfrotto site is not clear if AX700 is supported.

You have to cross fingers 🤞

[cgarlick]

Thanks danardeng will certainly give that a go. 

Regards

Chris

[cgarlick · Accepted solution]

Sadly it did not work.

Regards Chris

[cgarlick]

I feel the Camera may not be compatible to the Manfrotto Gimbal.

Regards

Chris

[danardeng]

But are you able to stabilize the camera without cable connection?

[cgarlick]

Yes, the Camcorder I found was easy to Balance etc